Collimation screws for the primary mirror - RC scope - Forums

Topic starter

Apr 1, 2023 · Edited: Apr 1, 2023

Hi,
I have a RC scope. There are three pairs of these screws around the primary mirror (in the back of the telescope). I know that 3 screws are for adjusting the mirror position and the other 3 are for locking its position after adjustment.

I know that is "rare" that a primary needs to be adjusted on a RC scope, but I want to understand how it works the collimation with these screws, if I need to do it someday.

- the bigger screws are the ones for adjustment and the smaller screws are the locking ones, right?
- it is recommended to adjust ONE pair at a time, and avoid untightnening all the locking screws at the same time because that can mess up the focal lenght, correct?

The idea that I have (correct me if I'm wrong please) is that the procedure must be done in this order:
- untighten ONE lock screw
- adjust (tighten or untighten, depending on how much I want to adjust/move the mirror) the bigger screw of the SAME pair
- tighten the lock screw again of the first step
> move to the next pair

Thank you,
Clear Skies

Engaging

Chris Jensen

Apr 2, 2023

I dont have an RC scope, but this does appear to be a good tutorial. https://youtu.be/-iW_OmRDndk

Hope it helps

Ed Dixon

Apr 2, 2023

My iOptron RC6 was brand new and still needed to be collimated with adjustments to both ends.

Well Written

vercastro

Apr 2, 2023

I think you're good to loosen all the locking screws at once by a bit then adjust the collimation screw. The collimation screw should hold on their own temporarily.

Having said that, this design looks different than what I'm used to (RC10 tube maybe?) and the mechanics might be slightly different.

Markus Gorski

Apr 2, 2023

Hello,
only two pairs of screws should be used to collimate the primary mirror, and always the same ones. Otherwise there is a risk that the distance between the primary and secondary mirrors will change. This resulted in a maladjustment that is not so easy to eliminate.
Best regards!

Helpful Concise

Isabela Chase

May 1, 2023

Hey there, I can totally understand your concern about adjusting the collimation screws on your RC scope. I am new to this forum, but I had a similar issue with my own telescope a while ago.

Well Written Respectful

Related discussions

Mono or OSC camera?

Hi again, I asked before many times about a scope to be as my third option or setup to use, and i didn't decide on anything yet for some reasons until recently i saw a new scope that is like 90-98% is the answer to my question, then this will lea...

Sep 12, 2023

Both posts involve telescope owners seeking advice about technical aspects of their equipment setup and maintenance.

Full rig recommendations for beginners

So I put together this list of my personal recommendations for some beginner astrophotography rigs. It was an idea for a youtube video that I uploaded and I thought I share them here and see the community's feedback! One of the most frustrating t...

Aug 27, 2024

Both posts involve telescope users seeking to understand and share practical knowledge about equipment setup and maintenance procedures.