Recently i bought an ioptron cem70. for several nights i used it. but last night during working and slewing some times could not slew. so i switch it off. after 1 minute I brought it to zero position manually, then i switched on, but power button could not illuminated and the hand controller turned on and just show ioptron logo. and then after few seconds this message came up: "Connection error detected in following board(s): Main Board".
ioptron advised me to check power source, HC cable and sockets, etc. finally I should send HC and main-board to the ioptron office to checking and repairing.
It will be free of charge except S&H if the mount is under 2 year warranty.
ioptron advised me to check power source, HC cable and sockets, etc. finally I should send HC and main-board to the ioptron office to checking and repairing.
It will be free of charge except S&H if the mount is under 2 year warranty.
